Raider 4WD V6-3.7L SOHC (2007)
2. Carefully position the door onto the hinges and support the door with a suitable lifting device.
Note: If the epoxy bonded washers are separated from the hinges, the door may need to be adjusted.
3. If removed, install the epoxy bonded washers.
4. Loosely install the two nuts (2) and the two bolts (1) that secure the door to the hinges.
5. Align the door to the hinges using the reference marks made during the removal procedure and tighten the nuts and bolts to 28 Nm (21 ft. lbs.)
using the sequence shown.
6. Connect the door wire harness to the body wire harness.