Raider 4WD V6-3.7L SOHC (2007)
NOTE: Exterior nameplates are attached to body panels with adhesive tape.
1. Apply a length of masking tape on the body, parallel to the top edge of the nameplate to use as a guide, if necessary.
2. If temperature is below 21° C (70° F) warm emblem with a heat lamp or gun. Do not exceed 52° C (120° F) when heating emblem.
3. Insert a plastic trim stick or a hard wood wedge behind the emblem to separate the adhesive backing from the body.
4. Clean adhesive residue from body with a cleaning solvent.
INSTALLATION