Raider 4WD V6-3.7L SOHC (2007)
6. Disconnect the A/C liquid line and the A/C accumulator from the A/C evaporator and install plugs into or caps over the fittings and evaporator
tubes.
7. Disconnect the heater hoses from the heater core tubes and install plugs into or caps over the heater core tubes.
8. Remove the three nuts (1) that secure the HVAC housing (2) and the fresh air inlet screen (3) to the engine compartment side of the dash panel (4).
9. Pull the HVAC housing assembly rearward so that the mounting studs and condensate drain tube clear the dash panel and remove the HVAC
housing from the passenger compartment.
10. If required, remove the fresh air inlet screen from the dash panel.
AIR INLET HOUSING
WARNING:
-
Refer to the applicable warnings and cautions for this system before performing the following operation. Failure to follow the warnings
and cautions could result in possible personal injury or death.
-
On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, or instrument panel
component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system
capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to
take the proper precautions could result in accidental airbag deployment and possible personal injury or death.
NOTE: The air inlet housing must be removed from HVAC housing and disassembled for service of the recirculation-air door.