Raider 4WD V6-3.7L SOHC (2007)
1. Remove the air inlet housing (1) from the HVAC housing and place it on a workbench.
2. Remove the recirculation door actuator from the air inlet housing.
3. Remove the blower motor resistor from the air inlet housing.
NOTE: If the foam seal on the air inlet housing is deformed or damaged, the seal must be replaced.
4. Carefully cut the foam seal (2) along the parting line (3) of the two halves of the air distribution housing.
5. Remove the four screws (4) that secure the two halves of the air distribution housing together and separate the housing.
NOTE: If the seal on the air door is deformed or damaged, the air door must be replaced.
6. Remove the recirculation-air door (5) from the air inlet housing.
HOUSING - HVAC - ASSEMBLY
HVAC HOUSING
NOTE: The HVAC housing must be removed from the vehicle and disassembled for service of the heater core, A/C evaporator, mode-air and blend-air
doors.