Raider 4WD V6-3.7L SOHC (2007)
8. Disconnect the wire harness connector (2) from the Sentry Key REmote Entry Module (SKREEM) (1).
9. On vehicles equipped with the optional remote start system, disconnect the coaxial cable from the coaxial connector receptacle on the SKREEM.
10. Remove the screw (2) that secures the SKREEM (1) to the steering column housing.
11. Disengage the antenna ring (3) from around the ignition lock cylinder housing (4) and remove the SKREEM.
INSTALLATION
WARNING: To avoid personal injury or death, on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect
and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further
diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result
in accidental airbag deployment.
1. Position the Sentry Key REmote Entry Module (SKREEM) (1) onto the steering column with the antenna ring (3) oriented around the ignition lock
cylinder housing (4).
2. Install and tighten the screw (2) that secures the SKREEM to the steering column housing.Tighten the screw to 2 N.m (20 in. lbs.).
