Raider 4WD V6-3.7L SOHC (2007)
Hood Sensor/Switch (For Alarm): Service and Repair
HOOD AJAR SWITCH - REMOVAL
1. Unlatch and open the hood.
2. Disconnect and isolate the battery negative cable.
3. From the top of the left outboard end of the cowl plenum cover/grille panel, squeeze the two hood ajar switch latch tabs (2) together and pull the
switch upward out of the mounting hole (1).
4. Pull the hood ajar switch up through the mounting hole far enough to access and disconnect the wire harness connector (3) from the switch
connector receptacle.
5. Remove the hood ajar switch from the vehicle.
HOOD AJAR SWITCH - INSTALLATION
1. Position the hood ajar switch (2) near the mounting hole (1) in the left outboard end of the cowl plenum cover/grille panel.
2. Reconnect the wire harness connector (3) to the switch connector receptacle.
3. Insert the switch into the mounting hole until the integral switch latch tabs lock it into place.
4. Reconnect the battery negative cable.
5. Close and latch the hood.