Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual17 · CL clutch
17 · Transmission

INSPECTION AND ADJUSTMENT - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › INSPECTION AND ADJUSTMENT - Nissan 180SX S13 Workshop Manual
CL clutchINSPECTION AND ADJUSTMENT - Nissan 180SX S13 Workshop Manual

INSPECTION AND ADJUSTMENT

INSPECTION AND ADJUSTMENT

—

Adjusting Clutch Pedal

_

1. Adjust pedal height with pedal stopper. Pedal height ‘H”: L.H. 186 - 196 mm (7.32 - 7.72 in) Pedal bracket Push rod R.H. 182 - 192 mm (7.17 - 7.56 in)

2. Adjust pedal free play with master cylinder push rod. Then tighten lock nut. Pedal free play “A”: ' Pedal stopper lock nut

1.0 - 3.06 mm (0.039 - 0.118 in) Lock nut 416-22 t d 8-11 (1.6 - 2.2, 12-16) t Pedal free play means the following total measured at posi- ' (0.8 - 1.1, tion of pedal pad:

5.8 - 8.0) @ Play due to clevis pin and clevis pin hole in clutch pedal. @ Play due to piston and push rod.

Dash lower panel Melt sheet

Cc) > Nem {kg-m, ft-lb) SCL323

Bleeding Procedure

Bleed air according to the following procedure. Clutch connector > Clutch operating cylinder @ Carefully monitor fluid level at master cylinder during bleed- ing operation. o Top up reservoir with recommended brake fluid. Connect a transparent vinyl tube to air bleeder valve. Fully depress clutch pedal several times. With clutch pedal depressed, open bieeder valve to release BOOP air. 7 Close bleeder vaive.

6. Repeat steps 3 through 5 above until brake fluid flows from air bleeder valve without air bubbles.

XO Clutch operating cylinder

SCL20g

CL-5

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.