300ZX Coupe V6-2960cc DOHC (VG30DE) (1994)
Paint: All Technical Service Bulletins
Paint - Clear Coat Polishing Procedures
Classification: BF94-017
Section: Body/Frame
Reference: TECHNICAL BULLETIN NTB94-061
Models: See Below
Date: June 9, 1994
NEW CROSS-LINKING CLEAR COAT (NCLC) POLISHING PROCEDURE
This Technical Bulletin revises the polishing procedure which was first outlined in NTB94-015 (BF94-003) entitled, "Paint Contamination Identification
And Repair".
APPLIED MODELS:
1995 Maxima Dark Colors (1)
1995 240SX Dark Colors (2)
1994 30OZX All Colors
(1)
ALO-Ruby Pearl
(2)
AJ4-Ultra Red
BM1-Deep Blue Pearl
ALO-Ruby Red
DJ2-Black Emerald
FN2-Blue Emerald
KH3-Black
KH3-Black
KN6-Granite Pearl
LN1-Concord Gray
SERVICE INFORMATION:
If it is necessary to remove fine scratches (swirl marks, buff/polish marks) for vehicles with New Cross-Linking Clear Coat (NCLC/hard clear coat) paint
, use the recommended equipment and materials and follow the revised Service Procedure.
SERVICE PROCEDURE:
1.
Vehicle/Panel Preparation
a.
Thoroughly rinse vehicle to remove surface dirt or dust (shady area preferred). If vehicle is extremely dirty, wash vehicle with soap and
water (consistent with Nissan car wash procedures).
b.
Prior to polishing, ensure painted surfaces are dry and cool to the touch and completely free of dust and water spots.
2.
Polishing (equipment/materials)
a.
Polishing to remove fine scratches requires a foam polishing pad with only a dual action sander.
Caution:
Do not use an orbital (rotational) buffer with a foam or wool pad.
b.
For isolated fine scratches, polish the affected area of each panel (e.g., hood, deck lid, door panel). For cases of more extensive fine scratches, it
may be necessary to polish the entire panel.
c.
Spread the glaze around with the pad before turning the sander "ON". For best results, keep the pad nearly flat and move it slowly but