nissan Workshop Repair Guides

Nissan and Datsun Workshop Service and Repair Manuals

Steering - Pull/Drift|Page 4959 > < Steering - Pull/Drift|Page 4957
Page 3
background image

The vehicle has a tendency to drift to the right or left depending on road surface conditions. Wander can occur as a result of too little caster (incorrect
wheel alignment), steering rack Sliding Force setting or incorrect road wheel offset. See figure 3

Pull When Braking

The vehicle consistently drifts to one side when the brakes are applied. This condition can occur as a result of excessive play in suspension bushings or
components, or because of uneven braking force.

CLAIMS INFORMATION

Please reference the current Nissan "Warranty Flat Rate Manual" and submit your claim(s) using the Operation Code (Op Code) or combination of Op
Codes that best describes the operations performed.

Service Procedure

1.

Verify the condition by road testing the vehicle with the customer using the Steering Pull Diagnosis and Repair procedure below.

2.

Determine the specific pull condition based on the descriptions in the service information section of this bulletin.

3.

Perform the Preliminary Inspection outlined in this section of the bulletin.

4.

Follow the appropriate repair procedure outlined in this section of the bulletin.

Preliminary Steps

Always perform these preliminary steps before performing the other listed diagnosis and repair procedures.

1.

Check and adjust tire pressure. A pressure difference of 3 psi or more from one side of the car to the other can cause the vehicle to drift toward the
side with the lower pressure.

2.

Determine if the wheels and tires are the same as the wheels and tires that were originally supplied on the vehicle.

3.

Visually inspect the vehicle for unusual load conditions. Remove unusual loads before road testing.

4.

Visually inspect the tires for wear and condition. Replace tires that show damage or have excessive or uneven wear.

5.

If corrections are made to the tire pressure, vehicle load condition or tire condition, road test the vehicle again to determine if the incident
continues to occur. If so, refer to the appropriate diagnosis and repair information below.

Steering Pull Diagnosis And Repair

1.

Confirm the direction of pull with a road test.

2.

Remove the front wheels and exchange them left to right and right to left.

Steering - Pull/Drift|Page 4959 > < Steering - Pull/Drift|Page 4957