350Z V6-3.5L (VQ35) (2003)
Front Door Panel: Service and Repair
Removal and Installation
DRIVER DOOR FINISHER
Removal
1. Remove cap inside handle portion and remove screw.
2. Remove finisher power window main switch.
3. Disconnect harness connector power window main switch.
4. Remove screw of power window main switch portion.
5. Pull up door finisher and remove connector inside handle cable and lock knob cable.
Installation
Install in the reverse order of removal.
CAUTION: To install finisher, check if all clips are matched over holes of panel on vehicle, then push it.
PASSENGER DOOR FINISHER
Removal
1. Remove cap inside handle portion and remove screw.
2. Insert taping flat-bladed screwdriver into edge portion, disconnect pawls, and remove door grip finisher.
3. Remove screw of door grip portion.
4. Remove finisher power window sub switch.
5. Disconnect harness connector power window sub switch.