350Z V6-3.5L (VQ35) (2003)
Front Door Window Glass: Service and Repair
Disassembly and Assembly
DISASSEMBLY AND ASSEMBLY
Remove regulator motor and guide rail from module assembly.
SETTING AFTER INSTALLATION
Setting of limit switch
If any of the following work has been done set the limit switch (integrated in the motor).
-
Removal and installation of regulator.
-
Removal and installation of motor from regulator.
Resetting
After installing each component to vehicle follow the steps.
1. Raise glass to the top dead center.
2. While pressing and holding reset switch lower glass to the bottom dead center.
3. Release reset switch and check reset switch returns to the original position and then raise the glass to the top dead center.
CAUTION: Do not operate the glass automatically to raise the glass to the top dead center.
Do not operate the door switch is turning on.