350Z V6-3.5L (VQ35) (2003)
tabs (2) to remove mirror holder lower half side.
NOTE: When pushing up tabs do not attempt to use 1 recess only be sure to push up with both recesses.
Insert screwdriver into recesses and push up while rotating (twist) to make work easier.
4. Remove terminal (2) of mirror heater attachment.
5. Lightly lift up lower side of mirror surface from mirror surface and detach clips (2) of upper side as if pulling it out. Remove mirror surface from
mirror body.
NOTE: Be certain not to allow grease on sealing agent in center of mirror body assembly (actuator) or back side of mirror surface (mirror
holder).
ASSEMBLY
1. Place mirror holder bracket and mirror body assembly (actuator) in a horizontal position.
2. Connect terminal (2) of heater installed mirror.
3. Fit the upper tabs (2) on the mirror face onto the mirror holder bracket first then press the lower side of mirror face until a click sound is heard to
engage the lower tabs.
NOTE: After installation visually check that lower tabs (2) are securely engaged from the bottom of mirror face.