nissan Workshop Repair Guides

Nissan and Datsun Workshop Service and Repair Manuals

All Other Service Bulletins for Alignment:|00-037B > < Tires - Noisy When Braking|Page 2465
Page 4
background image

TPMS Initialization should not be needed if the "tips" above are followed, however, if TPMS Initialization is needed, see NTB02-070 for detailed
information.

4.

Remove the right-front and left-front wheels.

5.

Dismount the front tires from the wheels.

NOTE:

When remounting tires in the steps below, make sure the uni-directional arrows on the sides of the tires point toward the front of the vehicle (see
Figure 4)

6.

Mount the right tire on the left wheel.

7.

Mount the left tire on the right wheel.

8.

Adjust the tire pressures according to the tire placard located on the inside of the center console lid.

9.

Balance both wheel/tire assemblies.

10.

Mount the left wheel/tire assembly on the left side of the vehicle.

11.

Mount the right wheel/tire assembly on the right side of the vehicle.

12.

Verify the incident as described in the IF YOU CONFIRM section of this bulletin is no longer present.

All Other Service Bulletins for Alignment:|00-037B > < Tires - Noisy When Braking|Page 2465