Altima 2.5 SL L4-2.5L (QR25DE) (2002)
^
Remove one bolt to release the Wire Harness Support Bracket (see Figure H11).
Torx Sockets for Flywheel/Flex Plate to Crankshaft Bolts (Altima and Sentra)
^
Torx TP5O (J-45737): Use for M/T with engine number before (but not including) 308509Z
NOTE:
Do NOT use a standard T50 Torx bit as it can break or strip out.
^
Torx TP55 (J-46531): Use for M/T with engine number 308509Z and later
NOTE:
Do NOT use a standard T55 Torx bit as it can break or strip out.
^
Torx E20 Socket (J-45816): Use for all A/T equipped vehicles (W/ QR25DE engine).
NOTE:
Do NOT use a standard external Torx socket as it can "round off" the bolt head.
IMPORTANT:
Do NOT use an air tool with the above noted Torx bits/socket.
Installation Tips
Front Suspension Member 'Engine Cradle (Altima ONLY)
^
Install the front bolts securing the Front Suspension Member and allow the rear (of the suspension member) to hang down slightly. This will allow
access for re-installation of the components in this area.
^
Vehicle must be on the ground when torquing all Suspension Member mounting nuts.
Torque Converter to Flex Plate Securing (Altima and Sentra)