Cube L4-1.8L (MR18DE) (2010)
Two people shall perform the work to remove the rear bumper fascia so that it is not dropped.
7. Remove the rear bumper energy absorber.
8. Remove the trim clips to remove the rear panel assembly (LWR).
INSTALLATION
Install in the reverse order of removal.
-
Check the clearance when installing the rear bumper fascia assembly.
Disassembly And Assembly Of Rear Bumper Assembly
REAR BUMPER
Disassembly and Assembly of Rear Bumper Assembly
[Krom]
REMOVAL
1. Disconnect the tail harness connectors (right and left) to remove the rear side marker lamp assembly (LH, RH).
2. Remove tapping screws to remove the rear license bracket, license lamp assembly, and screw grommets.
3. Remove the tail harness.
4. Remove the rivets to remove the rear bumper cover (LH, RH).
INSTALLATION
Install in the reverse order of removal.