Cube L4-1.8L (MR18DE) (2010)
LUGGAGE REAR PLATE
1. Fully open back door.
2. Remove tonneau cover.
3. Remove back door weather-strip. See: Trunk / Liftgate Weatherstrip/Service and Repair/Removal and Installation/With Intelligent Key System.
4. Remove rope hook (1) mounting bolt with a socket wrench (A) and then remove rope hook.
5. Insert a remover tool between luggage rear plate and back door panel to disengage the fixing pawls and metal clips, and then remove luggage rear
plate.
LUGGAGE SIDE LOWER FINISHER
1. Remove luggage rear plate.
2. Recline rear seatback and then slide rear seat cushion and seatback toward vehicle front.
3. Remove rear body side welt. See: Interior Moulding / Trim/Trim Panel/Service and Repair/Removal And Installation.
4. Remove rear seatbelt floor anchor bolt. See: Restraint Systems/Seat Belt Systems/Seat Belt Buckle/Service and Repair/Rear Seat Belt/Exploded
View.
5. Remove luggage clip.
-
Insert a small minus driver into the hole of luggage clip.
-
Slide the minus driver to unlock the clip.
-
Remove luggage clip.
6. Pull out carefully luggage side lower finisher to disengage clips, pawls and metal clips.
7. Disconnect luggage room lamp harness connector. See: Lighting and Horns/Trunk Lamp/Service and Repair/Removal And Installation.
LUGGAGE SIDE UPPER FINISHER