Cube L4-1.8L (MR18DE) (2010)
Repair/Removal and Replacement/Exploded View.
4. Remove oil level gauge and oil level gauge guide.
5. Remove oil pump. See: Oil Pump/Service and Repair/Removal and Replacement/Exploded View.
NOTE:
The oil pan (upper) can be removed and installed without removing the oil pump.
6. Remove oil pan (upper) with the following procedure:
a. Loosen bolts in reverse order as shown in the figure.
Arrow Indicates : Engine front
b. Insert a screwdriver shown by the arrow (Black Arrow) in the figure and open up a crack between oil pan (upper) and cylinder block.
Arrow Indicates : Engine front
CAUTION:
A more adhesive liquid gasket is applied compared to previous types when shipped, so it should not be forced off the position not specified.
c. Insert seal cutter [SST: KV10111100 (J-37228)] between oil pan (upper) and cylinder block, and slide it by tapping on the side of the tool with
a hammer.
CAUTION:
Be careful not to damage the mating surface.
7. Remove O-ring between cylinder block and oil pan (upper).
INSTALLATION
1. Install oil pan (upper) with the following procedure:
a. Use a scraper (A) to remove old liquid gasket from mating surfaces.
-
Remove the old liquid gasket from mating surface of cylinder block.
-
Remove old liquid gasket from the bolt holes and threads.