Cube L4-1.8L (MR18DE) (2010)
CAUTION:
Never scratch or damage the mating surfaces when cleaning off old liquid gasket.
b. Apply a continuous bead of liquid gasket (C) with a tube presser (commercial service tool) as shown in the figure.
Use Genuine RTV Silicon Sealant or equivalent. See: Specifications/Fluid Type Specifications.
CAUTION:
-
Apply liquid gasket to outside of bolt hole for the positions shown by (Black Triangle) marks.
-
Attaching should be done within 5 minutes after liquid gasket application.
c. Install new O-ring at cylinder block side.
CAUTION:
Install avoiding misalignment of O-ring.
d. Tighten bolts in numerical order as shown in the figure.
Arrow Indicates : Engine front
2. Install rear oil seal with the following procedure.
CAUTION:
-
The installation of rear oil seal should be completed within 5 minutes after installing oil pan (upper).