Cube L4-1.8L (MR18DE) (2010)
Seals and Gaskets: Service and Repair
Removal And Installation
DIFFERENTIAL SIDE OIL SEAL
Removal and Installation
REMOVAL
1. Remove front drive shaft assembly. See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Overhaul/Exploded View.
2. Remove differential side oil seals using a flat-bladed screwdriver.
CAUTION:
Be careful not to scratch transaxle case and converter housing.
INSTALLATION
Note the following, and install in the reverse order of removal.
CAUTION:
-
Never reuse differential side oil seals.
-
Apply CVT fluid to differential side oil seals.
-
When insert drive shaft, always use a protector [SST: KV38107900 ( -- )]. See: Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Service and Repair/Overhaul/Exploded View.
Install drive shaft using drifts [SST: ST35325000 ( -- ) and KV31103000 ( -- )]. Check that side oil seal height difference from case end surface is
within the specified value "A" and "B".