Cube L4-1.8L (MR18DE) (2010)
11. Secure the large and small ends of the boot with boot bands using the boot band crimping tool [SST: KV40107300 ( -- )] (A).
CAUTION:
Never reuse boot band.
NOTE:
Secure boot band so that dimension (A) meets the specification as shown in the figure.
A : 7.0 mm (0.276 in) or less
12. Secure joint sub-assembly and shaft, and then check that they are in the correct position when rotating boot. Reinstall them using boot bands when
boot installation positions become incorrect.
CAUTION:
Never reuse boot band.
13. Clean the matching surface of wheel hub lock nut and wheel hub and bearing assembly.
CAUTION:
Never apply lubricating oil to these matching surface.
14. Insert drive shaft to wheel hub and bearing assembly, and then temporarily tighten wheel hub lock nut.
15. Install strut assembly to steering knuckle. See: Steering and Suspension/Suspension/Suspension Spring ( Coil / Leaf )/Service and
Repair/Procedures/Exploded View.
16. Install disc rotor. See: Brakes and Traction Control/Disc Brake System/Brake Caliper/Service and Repair/Removal and Replacement/Removal
And Installation.
17. Install caliper assembly to steering knuckle. See: Brakes and Traction Control/Disc Brake System/Brake Caliper/Service and Repair/Removal and
Replacement/Exploded View.
18. Install lock plate to strut assembly. See: Brakes and Traction Control/Hydraulic System/Brake Hose/Line/Service and Repair/Removal and
Replacement/Front/Exploded View.
19. Install wheel sensor and sensor harness to steering knuckle. See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Wheel
Speed Sensor/Service and Repair/Front Wheel Sensor/Exploded View.
20. Tighten the wheel hub lock nut to the specified torque. See: Wheel Hub/Service and Repair/Removal and Replacement/Front Wheel Hub and
Knuckle/Exploded View.
CAUTION:
Never use a power tool to tighten the wheel hub lock nut.
NOTE:
Perform the final tightening of each of parts under unladen conditions, which were removed when removing wheel hub and bearing assembly and axle
housing.
21. Install cotter pin. See: Wheel Hub/Service and Repair/Removal and Replacement/Front Wheel Hub and Knuckle/Exploded View.
CAUTION:
-
Never reuse cotter pin.