Frontier SC King Cab 4WD V6-3.3L SC (VG33ER) (2001)
48.
On the hydraulic press:
^
Place the backing plate/axle assembly (with ABS rotor ring installed) onto the "Hub and Bearing Assembly Support" (see Figure E44).
^
The number for this special tool is # J-46215-7 (see Figure E44).
49.
Using the "Outer Grease Seal Installer" special tool # J-46215-5 (with flat side down):
^
Press the ABS rotor ring onto the axle shaft until it is fully seated against the bearing lock nut (see Figure E45).
CAUTION:
Do NOT exceed 4.8 ton press load.
Procedure F: Broken ABS Sensor Bolt Removal
Using Kit # J-46215-8
CAUTION:
Wear suitable eye and hand protection when performing the following procedure.
1.
Insert a clean, lint-free shop rag into the end of the axle housing to keep dirt/debris/metal shavings from entering the housing during this
procedure.
2.
Thoroughly clean the area around the ABS sensor.