Frontier SC King Cab 4WD V6-3.3L SC (VG33ER) (2001)
3.
Install "Drill Jig" special tool # J-46215-9 into the ABS sensor hole (see Figure F1).
^
Firmly tighten the "T" handle on the Drill Jig.
4.
Using the supplied 3/16" "Left-Hand" drill bit:
^
Drill a hole completely through (approximately 6 mm drilling depth) the center of the broken off bolt (see Figure F2).
NOTE:
^
The drill motor that you use must be turned to the counterclockwise reverse direction.
^
Drill at a low to medium speed to avoid overheating the drill bit and dulling or breaking it.
^
If the broken bolt "backs out" (un-screws) when drilling, proceed to step 9. If it does not back out when drilling, continue with step 5.
5.
When the drilling is done, remove the Drill Jig.