Maxima Wagon V6-2960cc 3.0L SOHC MFI (VG30E) (1986)
7.
Remove stopper rings and retaining pins from 5th & Reverse and 3rd & 4th fork rods. When removing stopper rings, use snap ring remover and
installer (J34305).
8.
Remove 5th & Reverse and 3rd & 4th fork rods. Then remove forks and brackets.
9.
Remove both input and mainshafts with 1st & 2nd fork and fork rod as a set.
Input Shaft and Gears
DISASSEMBLY AND ASSEMBLY
^
Disassembling and assembling procedures are the same as those for models without input shaft braking mechanism, except as follows.
Installation of 5th & Reverse synchronizer assembly:
a.
Place 5th baulk ring on 5th input gear.
b.
Install reverse synchronizer cone on reverse baulk ring.