Murano AWD V6-3.5L (VQ35) (2003)
Windshield Washer Pump: Service and Repair
Removal and Installation of Washer Pump
REMOVAL
1. Remove fender protector (front).
2. Remove the right side of front bumper.
3. Disconnect washer pump connector and tube.
4. Pull out washer pump in direction shown by the arrow in the figure. Remove washer pump from washer tank.
INSTALLATION
Note the following, and install in the reverse order of removal.
CAUTION:
-
When installing washer pump, there should be no packing twists, etc.
-
Do not misconnect the front tube and the rear tube to each side when the washer tube is being connected to the washer bump.