Murano AWD V6-3.5L (VQ35DE) (2009)
2. When you get to the ECM Reprogramming screen shown in Figure 1, confirm this bulletin applies as follows:
A. On your C-III screen, look at the Part Number column (see Figure 1)
^
If this column is blank (no part number listed), this bulletin does not apply. Close C-III and refer to ASIST for further diagnostic information.
^
If a Part Number is listed, write it on the Repair Order.
B. Compare the Part Number you wrote down to the numbers in the Current ECM Part Number column in Table A above.
^
If there is a match, this bulletin applies. Continue with the reprogramming procedure.
NOTE:
If there are two lines (two reprogramming options) on your C-III screen, use the one that does not have the message "Caution! Use ONLY with
NTBXX-XXX".
^
If there is not a match, this bulletin does not apply. Close C-III and refer to ASIST for further diagnostic information.
3. If this bulletin applies and you have performed ECM reprogramming, the screen in Figure 2 appears when reprogramming is complete.
NOTE:
If the screen in Figure 2 does not display (reprogramming does not complete).
4. Make sure to erase DTCs from all Systems.
NOTE:
During the reprogramming, DTCs will set in several systems. DTCs must be erased from all systems.