Murano FWD V6-3.5L (VQ35) (2004)
^
Use felt cloth tape 68370-4B000, from the Squeak and Rattle Kit.
^
Cut 4 pieces of tape in half so you have a total of eight pieces.
^
Cut a slot in each piece so the metal tabs can pass through.
5.
Reinstall the waist molding.
a.
Hold/"compress" the molding tightly in place.
b.
Bend the metal tabs in their original direction to hold the waist molding.
^
Four (4) tabs towards the front of the vehicle should be bent forward.
^
Four (4) tabs towards the rear of the vehicle should be bent rearward.
Upper Door Panel Supports
(Refer to Figure 2 if needed.)