Murano FWD V6-3.5L (VQ35) (2004)
/Page-610002.png)
10. Remove exhaust front tube.
11. Remove the heated oxygen sensor 2 (bank 2) and remove the three way catalyst (manifold) (bank 2) from the exhaust manifold.
12. Loosen lower oil pan bolts with power tool in reverse order of illustration to remove.
13. Insert a seal cutter (special service tool) between the lower oil pan and the upper oil pan.
CAUTION:
^
Be careful not to damage the mating surface.
^
Do not insert a screwdriver, this will damage the mating surfaces.
14. Slide seal cutter (special service tool) by tapping on the side of the tool with a hammer. Remove lower oil pan.
15. Remove oil strainer.
16. Remove the oil pressure switch.
17. Remove crankshaft position sensor (POS).
CAUTION:
^
Handle carefully to avoid dropping and shocks.
^
Do not disassemble.
^
Do not allow metal powder to adhere to magnetic part at sensor tip.
^
Do not place sensors in a location where they are exposed to magnetism.