Pathfinder Armada 4WD V8-5.6L (VK56) (2004)
2.
Connect the AC power supply to CONSULT-II.
3.
Connect CONSULT-II to the ASIST PC with the special Ethernet cable (P/N 02002554 is printed on the cable).
a.
Connect one end to CONSULT-II at the "PC port".
b.
Connect the other end to the ASIST PC at the "Ethernet card" connection port.
4.
Confirm the CONSULT-II date and time are correctly set as follows:
(This is necessary to provide a valid print-out for warranty claims.)
a.
With the 8 MB (orange) Reprogramming card in slot A, turn ON CONSULT-II.
b.
Touch [SUB MODE]
c.
Touch [SET DATE] (see Figure 2).
1)
If the date is not correct, touch the [MONTH], [DAY] or [YEAR] as needed. Then adjust it by using arrow keys. Once done, press
[SAVE], press [BACK], and go to step d.
2)
If the date is OK, press [BACK] and go to step d.
d.
Touch [SET TIME] (see Figure 2).
1)
If time is not correct, touch the [HOUR], [MINUTE] or [AM/PM] as needed. Then adjust it by using arrow keys. After you are done,
press [SAVE], press [BACK] and go to step 5.
2)
If time is OK, press [BACK] and go to step 5.
IMPORTANT NOTE
^
If your ASIST PC has already been set up to perform ECU reprogramming, proceed to step 5.
^
If you are unsure whether your ASIST PC has already been set up for ECU reprogramming, look in ASIST, under "CONSULT Utilities" -
"CONSULT-II Info" - "NISSAN" - "ECU Reprogramming". This will give you instructions for setting the Ethernet (IP) Address of the ASIST
PC and CONSULT-II. You will need to do this before performing ECU reprogramming.
DOWNLOAD (TRANSFER) DATA FROM ASIST INTO CONSULT-II (8 MB Orange Card)