Stanza L4-2389cc 2.4L SOHC MFI (KA24E) (1991)
2.
Grind the surface of the repair with 36 grit disc. Grind about 11/2" around the actual damage to obtain a taper for best adhesion.
3.
Featheredge the paint around the repair with 180 grit disc. Wipe with a clean, dry rag and blow off with air.
4.
Apply one wet coat of Polyolefin Adhesion Promoter over the sanded surface and allow to dry for 10 minutes.
IMPORTANT:
It will be necessary to reapply Polyolefin Adhesion Promoter after any sanding step.
5.
Mix Flexible Parts Repair Material according to the instructions and apply to the repair with a squeegee, building it up higher than the undamaged
area. Allow it to cure for 20-30 minutes at 60-80~F.
6.
After curing, sand with 180 grit disc followed by 240 grit disc.