Aurora V6-214 3.5L VIN H SFI (2001)
Important: The EGR valve inlet pipe incorporates a crush seal connection at the water crossover. The EGR valve inlet pipe must be replaced if
disconnected from the water crossover.
5. Hand start the NEW EGR inlet pipe-to-crossover pipe nut (3) to prevent crossthreading.
Tighten
Tighten the EGR inlet pipe nut to 60 Nm (44 lb ft).
6. Connect the EGR inlet pipe flange to the water crossover.
7. Install the EGR inlet pipe-to-water crossover flange bolt (2).
Tighten
Tighten the EGR inlet pipe bolt to 24 Nm (18 lb ft).
Important: The EGR valve outlet pipe incorporates a crush seal connection at the water crossover. The EGR valve outlet pipe must be replaced
if disconnected from the water crossover.
8. Install the NEW EGR outlet pipe with NEW O-ring seal.
9. Install the EGR outlet pipe-to-intake manifold bolts.
Tighten
Tighten the EGR outlet pipe-to-intake manifold bolts to 10 Nm (89 lb in).
10. Install the EGR outlet pipe-to-water crossover bolts
Tighten
Tighten the EGR outlet pipe-to-water crossover bolts to 24 Nm (18 lb ft).
11. Install the EGR heat shield and EGR valve. Refer to Exhaust Gas Recirculation Valve Replacement See: Powertrain Management/Emission
Control Systems/Exhaust Gas Recirculation/EGR Valve/Service and Repair.
