Aurora V6-214 3.5L VIN H SFI (2001)
Camshaft Position Sensor: Service and Repair
CAMSHAFT POSITION (CMP) SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the mounting nuts retaining the coolant recovery tank.
2. Lift the coolant recovery tank to gain access to the camshaft position (CMP) sensor.
3. Disconnect the electrical connector from the CMP sensor.
4. Remove the CMP sensor mounting bolt (2).
5. Remove the CMP sensor (1) from the cylinder head.
^
Remove the sensor by pulling on the sensor connector. Do not pry on the bracket.
^
Do not rotate or twist the sensor or damage the mounting bracket if the sensor is being reused.
INSTALLATION PROCEDURE
IMPORTANT: When replacing the CMP sensor with a new sensor or reinstalling the original sensor, use the following recommended procedures:
^
Ensure that the CMP sensor bore is completely free of any foreign material, such as old O-ring, dirt, burrs, etc.
^
Ensure that the flange on the CMP sensor bore is not damaged.
^
Clean all of the mounting surfaces before re-installing any components.
^
Inspect the CMP sensor and replace the sensor if any of the following conditions are present:
-
The bracket is damaged.
-
The bottom of brass housing exhibits any damage.
-
Never install a sensor that has been dropped.
^
Lubricate the O-ring on the sensor with Amojell or clean engine oil prior to installing the sensor.
^
Check all of the connectors for any damaged terminals.