Aurora V6-214 3.5L VIN H SFI (2001)
2. Install the spring over the strut in the correct position.
3. Move the assembly upright in the strut compressor.
4. Install the upper locking pin (2).
5. Install the rod J34013-38 into the strut guide strut shaft.
6. Start turning the compressor screw clockwise on the J34013-B, while guiding the J34013-38 to the center strut shaft in the assembly.
7. Continue to turn the compressor forcing screw (3) on the strut compressor until the strut shaft threads are visible through the top of the strut
assembly (1).
8. Install the strut washer and retaining nut.
Notice: Refer to Fastener Notice in Service Precautions.
9. Remove the clamp J34013-20 from the strut shaft.
-
Tighten the strut mount retaining nut to 75 Nm (55 ft. lbs.) while holding the strut shaft with the socket.
10. Remove the strut from the strut compressor.
11. Install the strut assembly to the vehicle. Refer to Strut Assembly Replacement.
Suspension Strut Disposal
Suspension Strut Disposal
Caution: Use the proper eye protection when drilling to prevent metal chips from causing physical injury.
