Aurora V6-214 3.5L VIN H SFI (2001)
5. Install the spacer ring (2) on the halfshaft bar (1 ) in groove using J 8059.
Important Ensure that the counterbored face of the tripot joint spider (2) faces toward the end of the halfshaft bar (4).
6. Slide the tripot joint spider assembly (2) toward the spacer ring (1) as far as it will go on the halfshaft bar (4).
7. Install the halfshaft bar retaining ring in the groove of the halfshaft bar.
Important Ensure the trilobal tripot bushing (3) is flush with the face of the housing (1).
8. Place approximately half of the grease from the service kit in the halfshaft inboard boot. Use the remainder of the grease to repack the housing.
9. Install the trilobal tripot bushing (3) to housing.
10. Position the larger new boot retaining clamp (2) on the halfshaft inboard boot.
11. Slide the housing (1) over the tripot joint spider assembly on the halfshaft bar.
