Aurora V6-214 3.5L VIN H SFI (2001)
bar.
2. Position the small end of the joint boot (1 ) into the joint boot groove (3) on the halfshaft bar.
3. Mount J 41048 in a vise and proceed as follows:
3.1.
Position the outboard end (1) of the halfshaft assembly in tool J141048.
3.2.
Align the top of boot neck on the bottom die using the indicator.
3.3.
Place the top half of the J410480n the lower half of the J41048.
3.4.
Before proceeding, ensure there are no pinch points on the halfshaft inboard boot. This could cause damage to the halfshaft inboard boot.
3.5.
Insert the bolts (2).
3.6.
Tighten the bolts by hand until snug.
Notice: Refer to Fastener Notice in Service Precautions.
4. Align the following items:
^
The halfshaft inboard boot (1)
^
The housing
^
The swage ring (2)
Tighten each bolt of J41048 180 degrees at a time using a ratchet wrench. Alternate between each bolt until both sides are bottomed.