Calais FWD L4-151 2.5L (1985)
Power Window Control Module: Technical Service Bulletins
Windows - Updated Module Replacement Procedures
SUBJECT
REVISED QUARTER WINDOW MODULE
NUMBER: 88-T-70
REPLACEMENT PROCEDURES
CORP. REF. NO.: 871508
MODELS/YEARS
1985-88 CALAIS MODELS
DATE: May 1988
SECTION:
10
A new procedure has been developed for modular quarter window installation to prevent itching noise and paint damage. A tape has been released, part
number 12393610, to provide the required clearance of the module to the body. This tape is to be added to the module prior to installation.
It is also recommended that no urethane solvents or solvent cleaners be used on the window module as they could cause cracking or crazing of the plastic
module.
When removal or replacement of the quarter window module is required for any reason, the following installation procedure must be used.
REMOVAL:
Remove the quarter window module as described in the 1988 Body Service Manual.
CLEANING:
Do not use solvents of any kind on the plastic module material. Trim off any loose urethane material to prepare the module for installation.
FIGURE 1
INSTALLATION:
1.
Prime the quarter window glass molding and/or frame with black primer in urethane adhesive kit 9636067 or equivalent. Allow the primer to dry
five minutes.
2.
Apply tape, part number 12393610, to the inside surface of the outer flange of the window module for the entire periphery of the module and cut
off the excess. DO NOT REMOVE THE CLEAR LINER OF THE TAPE. (Figure 1)
