Cutlass V6-191 3.1L VIN M SFI (1998)
Stabilizer Bushing: Service and Repair
Rear Suspension
REMOVAL PROCEDURE
1. Raise the vehicle and suitably support the vehicle.
2. Remove the stabilizer shaft bracket nuts (6) from the rear suspension support (1).
3. Separate the bracket and remove the insulator.
INSTALLATION PROCEDURE
1. Install the insulator to stabilizer shaft and the stabilizer bracket.
2. Install the stabilizer shaft bracket nuts (6) to the rear suspension support (1).
Tighten
-
Tighten the link bolt to 69 N.m (51 lb ft).
3. Lower the vehicle.