Intrigue V6-3.8L VIN K (1998)
Body Control Module: Description and Operation
BCM Inputs
The following components provide direct input to the BCM, plus other systems can use this input information in order to carry out certain functions:
^
BCM Ground: Provides ground for BCM operation.
^
BCM Power: Provides voltage for BCM operation.
^
Courtesy Lights On: Provides the driver the ability to request illumination of the vehicle interior.
^
Crank Signal: Determines when the ignition switch is in the start position.
^
DRL Link: Provides an interface to the DRL control module allowing the BCM to determine the current ambient light operating mode for the
twilight sentinel feature.
^
Door Lock Switch: Door lock switch request to lock vehicle doors.
^
Door Locks: Provides voltage for door lock actuator operation.
^
Door Open: Provides door ajar status.
^
Door Unlock Switch: Door lock switch request to unlock vehicle doors.
^
Driver Door Open: Allows certain chime functions when the driver's door is open.
^
Driver Seat Belt Unfastened: Determines when the driver's seat belt is unfastened through the seat belt switch.
^
Exterior Lamps Off: Determines when the headlamp switch is in the OFF position.
^
Ignition 0 Signal: Determines when the ignition switch is in accessory, on, or start position.
^
Ignition 1 Signal: Determines when the ignition switch is on and start positions.
^
Illuminated Entry: Determines when an exterior door handle is pulled for interior courtesy light operation.
^
Key In Ignition: Determines when the key is fully inserted in the ignition key cylinder.
^
Park Brake Applied: Determines when the parking brake is applied.
^
Passlock Sensor Data: Reads the Passlock sensor security code.
^
RFA Link: Provides an interface allowing the transfer of keyless entry information from the Remote Control Door Lock Receiver (RCDLR).
^
Serial Data: provides an interface with the PCM, EBTCM, and the PC through the Class II serial data link.