405 L4-1905cc 1.9L (1989)
STEP 5:
-
Install the pull rods (10) in the threaded holes in the support bracket (6); tighten until they come in contact with the trunk floor crossmember
-
Install the counternuts (11) with flat washer part facing support bracket (6)
-
Tighten counternuts (11)
-
Install the spare tire buffer (1) onto the pull rods (10) and through the 6.5 mm hole drilled in Step 4
-
Install the buffer flange (7) onto the pull rods (10) using new retaining nuts (5)
-
Tighten until approximately 20 mm (0.78") of stud protrude through the nuts. A slight deformation of the buffer flange (7) is normal.
-
Check that the fuel line (15) is properly routed behind the buffer (1)
-
Reinstall:
-
fuel filter using the new "L" shaped bracket (21)
-
fuel pump on studs in support bracket (6), making sure to reinstall the fuel pump wire bracket at the same time
-
Align the brake line (d) to prevent contact and possible pinching of the fuel pump inlet hole
STEP 6: