405 L4-1905cc 1.9L (1989)
IMPORTANT WARNING: DO NOT DISCONNECT THE FUEL FILLER HOSE FROM THE TANK OR FILLER TUBE. OPEN THE HOSE
CLAMPS IN ORDER TO FIT THEM ON THE FUEL FILLER TUBE AND HOSE.
-
Remove the two original fuel tank filler hose clamps (18) and (19) by releasing the lock tabs with a flat-blade screwdriver
-
Install hose clamp (19) (red i.d. paint dot manufactured by "Awas") between filler tube and hose and tighten to a torque of 0.450 mdaN (40 in.lbs.)
-
Install hose clamp (18) between filler hose and tank; position clamp screw housing 30~ from center line shown on drawing. Tighten to a torque of
0.20 mdaN (18 in.lbs.)
STEP 7:
-
Cut the lower corner of the right side inner fender lip (e) (shaded area of drawing)
-
Apply a coating of rustproofing compound to the exposed edge of inner fender lip
-
Based on model type, cut and install the edge protector strips
(22)
as shown below and on next page
SEDAN:
(Fig. 1)
1
piece 220 mm (8.7") long
1
piece 120 mm (4.7") long
2 pieces 40 mm (1.6") long
-
Install the 120 mm protector along the lower right side inner fender lip, taking care to cover the area cut-out in Step 7
-
Install the 220 mm long protector along the side and bottom edge of the right side bumper mounting bracket
-
Install the two short 40 mm protector's on the leading edges of the right side bumper mounting bracket above and below the