405 L4-1905cc 1.9L (1989)
-
Remove screws (4) and cover plate.
-
Carefully remove plunger assembly (5). Set aside in a clean, lint-free towel. Be sure not to touch the machined surfaces of the plunger
assembly with your fingers.
-
Discard old shuttle valve spring (6).
PROCEDURE - Reassembly
-
Install new spring (P/N 0025.79), plunger assembly, cover plate, and screws in reverse order of disassembly.
NOTE:
The original shuttle valve spring on some 1989 model vehicles is substantially longer than, and can be replaced by, the new spring.
-
Place the gearshift lever in low gear (position "1").
-
Check the relative positions of the sector cams (7) and (8) in the transmission. Faces (A) and (B) must be aligned.