405 L4-1905cc 1.9L (1989)
-
Push in on sector cam (8) to ensure complete engagement.
-
Check to make sure that rod (9) is in place and that cam (10) is properly positioned (this is held in place by the pedal depressor).
-
Push shuttle valve (11) and piston (12) all the way into their respective bores.
-
Install the valve body. Make sure that the pin (13) engages the shuttle valve yoke (14) and shaft (15) engages the bore (16).
-
Install, without tightening, the ten valve body mounting bolts. Install the shortest at (a) and the longest at (b).
-
Remove the pedal depressor and check the operation of the throttle cable assembly.
-
Torque the ten valve body bolts to 8 mm (72 in.lbs.)
-
Reinstall the oil pan with a new gasket (P/N 2214.11) and drain plug washer (P/N 2106.06).
-
Refill with Dexron II or Mercom ATF (approximately 4.2 pints).
-
Run engine until hot; check fluid level with transmission in park and engine running.
-
Check for leaks.
-
If necessary, adjust kick-down cable as per Service Bulletin 415, Class 3.
-
Road test vehicle after repair.
WARRANTY INFORMATION:
This repair will be accepted when performed within the Powertrain Limited Warranty period of five (5) years and/or 50,000 miles, whichever occurs
first.
Damage Code:
004201
