To adjust

To adjust

• Assemble Fig. I the dial gauge assembly 8.0504 ZZ comprising :
  1. A1 - support rod,
  2. A2 - support,
  3. A3 - clamp.
• By pushing in each direction ( ↔ ) Fig. I, on the threaded rod B1, check the end float : 0.025 to 0.10 mm.

If necessary, adjust the end float :

Shims available : 1,000 - 1,025 - 1,050 - 1,075 - 1,10 - 1,20 - 1,30 - 1,40 - 1,50 - 1,60 - 1,70 - 1,80 1,90 - 2,10 - 2,20 - 2,30 - 2,40 mm.

• Remove the tools and the components.

To assemble

• Lubricate and place in position Fig. III the inner bearing assembly (2) and the new oil seal (1).
• Place the stub axle with these parts on the hub (7) Fig. III and use the tube 0.0607 to drive the inner bearing (2) on the hub until it butts.
• Position centrally on the hub Fig. IV :
  1. a shim (4) as previously determined,
  2. the spacer (3),
  3. the second adjusting shim (4).
• Lubricate the inner bearing assembly (5), place it in position and drive it on the hub using tube 0.0607 Fig. IV.
• Lubricate and fit a new oil seal (6).