Tightening torques :

– The largest offset on the drive dog, fig. I, should then be towards the rear of the engine and No. 1 cylinder should be at its firing point.

If not, turn the crankshaft through a complete turn and re-align the notch in the pulley with the index on the timing plate.

Refit the various engine accessories as shown in fig. IV.

• Push the distributor fully in, fig. II.
• Find the point at which the contact breaker points open.
• Lock the distributor in this position.

Refit the water pump, fig. III

Fit new rubber seals.

Tightening torques :

• 8 mm nuts : 2.25 m.daN (22.5 Nm, 17 lbf ft).
• 10 mm nuts : 4.25 m.daN (42,5 Nm, 31 lbf ft).
• 10 mm bolts : 2.75 m.daN (27,5 Nm, 20 lbf ft).