Dismantling

DISMANTLING

Remove, fig. I, the outer bearing inner track (5) and cage.

Fit, figs. II, III and IV, the outer tracks (3) and (4) using the drift and the mandrel (items A1 and A4 from kit 8.0531 ZZ)

Remove, figs. II and III

• the seal (1) and inner track (2),
• the outer track (3), by driving it out,
• the outer track (4), by driving it out.

Fit, fig. V :

• the inner track (2),
• a new seal (1).

Clean all the parts.

REASSEMBLING

Grease all the parts and partially fill the inside of the hub with ESSO MULTIPURPOSE grease 4746.