Alignment (Alignment Specifications): Specifications
- Make
- Plymouth
- Model
- Breeze
- Engine
- L4-2.4L VIN X
- Year
- 2000
- Section
- Alignment › Specifications › Alignment Specifications
Alignment: Specifications
Front Wheel Alignment
Camber
Acceptable Range -0.6 to +0.6 deg
All specifications are given in degrees. All wheel
alignments are to be set with the vehicle at its
proper curb height.
Preferred
0.0 deg
Cross Camber
Acceptable Range 0.7 or less deg
Preferred
0.0 deg
Toe - Right/Left
Acceptable Range 0.05 degrees out to 0.15 degrees in
Preferred
0.05 degrees in
Total Toe (Specified In Degrees)
Acceptable Range 0.1 degrees out to 0.3 degrees in
Preferred
0.1 dregrees in
Caster
Acceptable Range +2.3 to +4.3 deg
Preferred
3.3 deg
Caster Difference (Side To Side)
Acceptable Range 1.0 degree or less
Preferred
0.0 deg
Rear Wheel Alignment
Camber
Acceptable Range -0.6 to + 0.2 deg
All specifications are given in degrees. All wheel
alignments are to be set with the vehicle at its
proper curb height. Refer to Curb Height Measurement
in Service and Repairs.
Preferred
-0.2 deg
TOE - Right/Left
Acceptable Range 0.05 degrees out to 0.15 degrees in
Is TOE OUT When Backed On Alignment Rack Is
TOE IN When Driving
Preferred
0.05 degrees in
Total Toe (Specified In Degrees)
0.1 degrees out to 0.3 degrees in
Total toe is the sum of the left and right
wheel toe settings. Positive is toe in,
negitive is toe out. Total toe must be equally
split between each front wheel to ensure the
steering wheel is centered after setting toe.
Left and right toe must be equal.
0.1 degrees in
Thrust Angle
+ or - 0.15 deg
0.0 deg
Pinch or Ctrl + scroll to zoom. Double-tap to reset.
Parts & tools for this job For 2000 Plymouth Breeze 2.4L
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: Plymouth power steering fluid
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.