Grand Voyager V6-3.0L VIN 3 (1998)
attaching bolt to a torque of 12 Nm (105 inch lbs.).
13. Install the park brake cable into its mounting hole in the adapter. Be sure all the locking tabs on the park brake cable retainer are expanded out to
ensure the cable will not pull out of the adapter.
Park Brake Cable Attachment To Actuator
14. Install the end of the park brake cable on the park brake actuator lever.
NOTE: The horseshoe clip must be installed and installed properly when the park brake cable is installed in the adapter. The purpose of the
horseshoe clip is to prevent park brake cable retainer from moving in the adapter. If horseshoe clip is not installed the park brake cable retainer
will rattle in the adapter.
15. Install a NEW horseshoe clip on the park brake cable retainer. The horseshoe clip is installed between the retainer for the park brake cable and the
adapter. Horseshoe clip must be installed with the curved end of the clip pointing straight up and the edge of the curved end facing toward the rear
of the vehicle.
Locking Out Automatic Adjuster
16. Remove the locking pliers from the front park brake cable.
17. Adjust the park brake drum-in-hat brake shoes.
18. Install the rotor on the hub/bearing.
