Grand Voyager V6-3.8L VIN L (1999)
Installing Tone Wheel On Hub/Bearing Assembly
1. Place hub/bearing assembly in an arbor press supported by Receiver, Special Tool, 6062A-3. Position Driver, Special Tool 6908-1 with undercut
side facing up on top of the tone wheel.
Correctly Installed Tone Wheel
2. Press the tone wheel onto the hub/bearing assembly until it is flush with the end of hub shaft.
3. Install the 4 hub/bearing to axle flange mounting bolts into the 4 mounting holes in the flange of the rear axle.
4. Install the rear brake support plate on the 4 mounting bolts installed in the flange of the rear axle.
5. Align the rear hub/bearing assembly with the 4 mounting bolts and start mounting bolts into hub/ bearing assembly. Tighten the 4 bolts in a
criss-cross pattern until the hub/bearing and brake support plate is fully and squarely seated onto flange of rear axle.
6. Tighten the 4 hub/bearing mounting bolts to a torque of 129 Nm (95 ft. lbs.)
7. Install the rear wheel speed sensor on the rear hub/bearing flange. Install the speed sensor attaching bolt and tighten to a torque of 12 Nm (105
inch lbs.).
8. Check the air gap between the face of the wheel speed sensor and the top surface of the tone wheel. Air gap must be less then the maximum
allowable tolerance of 1.2 mm (0.047 inches).
9. Install the brake drum onto the rear hub/bearing assembly.
10. Install rear wheel and tire assembly, tighten wheel stud nuts to 129 Nm (95 ft. lbs.).
11. Adjust the rear brakes.
