Workshop Repair Manuals

Plymouth Workshop Manuals

[PREV PAGE] [NEXT PAGE]

plymouth Workshop Repair Guides


PB 150 V8-318 5.2L VIN T 2-BBL (1983)

Sensors and Switches > Sensors and Switches - Cruise Control > Speed Control Switch <--> [Cruise Control Switch] > Component Information > Testing and Inspection > Page 211

Page 1
background image

Speed Control Switch: Service and Repair

Fig. 22 Removing wire terminals

REAR WHEEL DRIVE MODELS

1. Disconnect battery ground cable.
2. Disconnect speed control connector at lower end of column.
3. Remove steering wheel.
4. Remove turn signal switch, then the lever attaching screws.
5. Remove steering column cover plate to gain access to lead wires at lower end of switch, then remove wires and terminals from connector using

tool No. C-4135 or equivalent.

6. Tape terminals, then remove lever and wires.
7. Reverse procedure to install. A guide wire will be required to install wiring harness of new speed control switch through steering column

opening. On tilt or telescopic steering columns, insert guide wire through turn signal lever opening in column.

Sensors and Switches > Sensors and Switches - Cruise Control > Speed Control Switch <--> [Cruise Control Switch] > Component Information > Testing and Inspection > Page 211

[PREV PAGE] [NEXT PAGE]