Workshop Repair Manuals

Plymouth Workshop Manuals

[PREV PAGE] [NEXT PAGE]

plymouth Workshop Repair Guides


Prowler V6-3.5L VIN G (1999)

Brakes and Traction Control > Disc Brake System > Brake Caliper > Component Information > Service and Repair > Removal and Installation > Page 3558

Page 12
background image

Correctly Supported Disc Brake Caliper

7. Support disc brake caliper by hanging it from the shock absorber bracket on the frame, using wire or a tie strap. Do not let the flex hose support

the weight of the brake caliper, damage to the flex hose can occur.

Note:  If rotor retainers are on the wheel mounting studs they must be remove before attempting to remove rotor. They do not need to be installed
when rotor is installed back on hub bearing.

8. Remove rotor from hub/bearing.

Stub Shaft Retaining Nut

9. Remove stub shaft to hub/bearing retaining nut.

Special Tool 6790 Installed On Hub/bearing

10. Install Puller, Special Tool 6790 on flange of hub/bearing. Place puller bolt in center of stub shaft.

Brakes and Traction Control > Disc Brake System > Brake Caliper > Component Information > Service and Repair > Removal and Installation > Page 3558

[PREV PAGE] [NEXT PAGE]