Prowler V6-3.5L VIN G (1999)
Valve Cover: Service and Repair
Spark Plug Tube
Removal
1. Remove cylinder head cover.
Servicing Spark Plug Tubes
2. Using locking pliers remove the tube from the cylinder head. Discard old tube.
3. Clean area around spark plug with Mopar (R) Parts Cleaner or equivalent.
Installation
1. Apply Mopar(R) Stud and Bearing Mount to a new tube approximately 1 mm (0.039 inch) from the end of tube, in a 3 mm (0.118 inch) wide
area.
2. Install sealer end of tube into the cylinder head. Then carefully install the tube using a hardwood block and mallet. Install the tube until it is seated
into the bottom of the bore.
3. Install cylinder head cover.